Share some CCP-N 1Y0-351 exam questions and answers below.
As a result of connecting two NetScaler interfaces in the same L2 broadcast domain/VLAN (unless link aggregation is configured), the NetScaler will __________. (Choose the correct option to complete the sentence.)
A.restart
B.disable one interface
C.cause a network loop
D.disable both interfaces
Answer: C
Scenario: A NetScaler Engineer has enabled the HTTP Compression feature on an existing production NetScaler. The engineer is using the built-in policies. The engineer reviews the HTTP Compression statistics but does NOT see any compression statistic data.
What is the likely reason?
A.SSL protocol is being used for encryption.
B.The Compression Policy engine is set to default.
C."Allow Server side compression" is checked on the NetScaler.
D.Responses with the Content-Length or Chunked header are being sent from the server.
Answer: C
Scenario: Users in an organization need to access several web applications daily. Management has asked a NetScaler Engineer to reduce the amount of times users have to enter credentials when accessing web applications.
What should the engineer configure to meet this requirement?
A.A load-balancing VServer and an authorization policy
B.An authentication VServer and an authorization policy
C.An authentication VServer and an authentication policy
D.A content switching VServer and an authentication profile
Answer: C
Which service setting would a NetScaler Engineer use in the command-line interface to limit connections to server resources?
A.-maxReq
B.-maxClient
C.-monThreshold
D.-maxBandwidth
Answer: B
What is the purpose of the SSL Certificate Authority (CA) root certificate during an SSL connection?
A.SSL Cipher Exchange
B.Session Key Exchange
C.Pre Shared Master Secret Generation
D.Server Certificate Signature Verification
Answer: A
A company has an external-facing web application that requires end-to-end encryption and Layer7 functionality.
Which protocol type would an engineer choose for the virtual server and service?
A.SSL
B.SSL_TCP
C.SSL_PUSH
D.SSL_BRIDGE
Answer: B
Scenario: A NetScaler Engineer has discovered that the object home.php is NOT found in the cache on the system.
Below is the relevant configuration:
add cache contentGroup cache_content_group_1 -relExpiry 0
add cache policy cache_pol_1 -rule "http.REQ.URL.CONTAINS(\"home.php\")" -action MAY_CACHE -storeInGroup cache_content_group_1
add cache policy cache_pol_2 -rule "http.REQ.METHOD.EQ(\"GET\")" -action NOCACHE add cache policy cache_pol_3 -rule "HTTP.RES.HEADER(\"Set-Cookie\").EXISTS" -action NOCACHE
bind cache global cache_pol_1 -priority 90 -gotoPriorityExpression END -type REQ_OVERRIDE
bind cache global cache_pol_2 -priority 100 -gotoPriorityExpression END -type REQ_OVERRIDE
bind cache global cache_pol_3 -priority 100 -gotoPriorityExpression END -type RES_OVERRIDE
The data from the client and the server are as following:
GET /home.php HTTP/1.1
Host: www.website.com
User-Agent: Mozilla Firefox/3.0.3
Accept: text/html,application/xhtml+xml,application/xml;q=0.9,*/*;q=0.8
Accept-Language: en-us,en;q=0.5
Accept-Encoding: gzip,deflate
Accept-Charset: ISO-8859-1,utf-8;q=0.7,*;q=0.7
Keep-Alive: 300
Connection: keep-alive
Date: Thu, 09 Oct 2014 18:25:00 GMT
Cookie: sessionid=100xyz
HTTP/1.1 200 OK
Date: Thu, 09 Oct 2014 18:25:00 GMT
Server: Apache/2.2.3 (Fedora)
Last-Modified: Wed, 09 Jul 2014 21:55:36 GMT
ETag: "27db3c-12ce-5e52a600"
Accept-Ranges: bytes
Cache-Control: private, max-age=0
Set-Cookie: sessionid=100xyz; expires=Thu, 09-Oct-2014 18:30:00 GMT; path=/
Content-Length: 119
Connection: close
Content-Type: text/html; charset=UTF-8
Why does the object NOT persist in the cache?
A.The request is a GET request.
B.The response has Set-Cookie.
C.The content group is missing a cache selector.
D.The content group has been configured with relExpiry 0.
Answer: B
A NetScaler Engineer has created a new custom user monitor script and needs to place it in the NetScaler filesystem for use.
Where must the engineer place the custom script so that it is available for use?
A./nsconfig/monitors
B./netscaler/monitors
C./var/nstemp/monitors
D./netscaler/monitors/perl_mod
Answer: A
The upgrade script copies the updated NetScaler kernel file to the __________ NetScaler directory. (Choose the correct option to complete the sentence.)
A./var
B./flash
C./nsconfig
D./flash/boot
Answer: B
Which two certificate formats are supported when creating a certificate key pair on the NetScaler? (Choose two.)
A.PEM
B.DER
C.PKCS7
D.PKCS12
Answer: A,B
Which setting must an engineer ensure is configured before a Subnet IP (SNIP) could be used to communicate with servers on the same network segment?
A.Static route is defined
B.USIP mode is enabled
C.USNIP mode is enabled
D.Default gateway is defined
Answer: C
Scenario: A NetScaler Engineer has been tasked with reconfiguring an existing NetScaler deployment. The engineer is currently running a high-availability (HA) pair of NetScaler 10.5 appliances, but the Vice President of IT has requested a more efficient way of preserving and balancing network resources and throughput while having a single point of management for the NetScaler appliances.
What should the engineer configure to satisfy the requirements outlined by the Vice President of IT?
A.Switch from traditional HA to -INC mode HA.
B.Break the HA pair and configure clustering instead.
C.Break the HA pair and configure three standalone NetScaler nodes.
D.Leave HA enabled and increase bandwidth to both NetScaler nodes.
Answer: B
Which two authentication types on the NetScaler support password changes? (Choose two.)
A.TACACS+
B.LDAP (TLS)
C.LDAP (SSL)
D.RADIUS (PAP)
E.LDAP (PLAINTEXT)
F.RADIUS (MSCHAPv2)
Answer: B,C
Traffic to which destination is sourced from the NetScaler IP (NSIP) by default?
A.NTP servers
B.Clients on the Internet
C.Load-balanced web services
D.Load-balanced authentication services
Answer: A
In order to configure integrated cache, a NetScaler Engineer would need to reboot the NetScaler when the integrated caching feature is __________ and cache memory limit is set to __________. (Choose the correct set of options to complete the sentence.)
A.enabled; zero
B.disabled; zero
C.enabled; non-zero
D.disabled; non-zero
Answer: A
Scenario: A NetScaler Engineer has created an SSL virtual server that utilizes SSL services. The engineer needs to configure certificate authentication from the NetScaler to the backend web services.
What should the engineer do to meet the requirements outlined in the scenario?
A.Bind a CA Certificate to the SSL Services.
B.Bind a Client Certificate to the SSL Services.
C.Create an SSL policy to present the Client Certificate to the web services.
D.Enable Client Authentication and set Client Certificate to mandatory on the virtual server.
Answer: B
Scenario: A NetScaler Engineer configures COOKIEINSERT persistence method for an HTTP VServer named 'myApp'. Many clients do NOT allow the persistence cookie to be set and application sessions fail as a result. All clients are behind a network address translation (NAT) gateway, which will insert the client IP address into an HTTP header called X-Forwarded-For.
Which command could the engineer execute to provide persistence for clients while still distributing the requests across the bound services?
A.set lb vserver myApp -persistenceType SOURCEIP
B.set lb vserver myApp -persistenceType NONE -lbmethod SRCIPDESTIPHASH
C.set lb vserver myApp -persistenceType COOKIEINSERT -timeout 0 -cookieName XForwarded-For
D.set lb vserver myApp -persistenceType NONE -lb method TOKEN -rule
"HTTP.REQ.HEADER(\"X-Forwarded-For\").VALUE(0)
Answer: D
Which two of the listed statements are true about Access Control Lists (ACLs) on the NetScaler? (Choose two.)
A.Extended ACLs may BRIDGE traffic.
B.Simple ACLs are bound on ALL interfaces.
C.Extended ACLs are evaluated after creation.
D.Simple ACLs are processed after Extended ACLs.
Answer: A,B
Which statement is true about interface link-state on the NetScaler?
A.Interface link-state is controlled by ifconfig in BSD.
B.Interface link-state is dependent on the HAMON setting.
C.Interface link-state CANNOT be brought down from the NetScaler.
D.Interface link-state on both appliances is unaffected by the force failover command.
Answer: C
In order to create a three-node NetScaler cluster, all nodes must __________ and __________. (Choose the two correct options to complete the sentence.)
A.be physical appliances
B.have Platinum licensing
C.be using the same build
D.be the same platform model
Answer: C,D
Passcert Citrix NetScaler 10.5 1Y0-351 dumps | Passcert are designed by highly experienced and certified trainer's that have put together the best Citrix NetScaler 10.5 1Y0-351 dumps | Passcert that will keep success on your 1Y0-351 exam. Please feel free to download our Citrix NetScaler 10.5 1Y0-351 dumps | Passcert. You will notice that our Citrix NetScaler 10.5 1Y0-351 dumps | Passcert are very well written and is the key in Passing Your 1Y0-351 exam on your first try, or your money back.and help you to pass the 1Y0-351 exam.
没有评论:
发表评论